Description

Eleaf iJust 2 coil (0.3 or 0.5ohm)

Replacement coil for the Eleaf iJust 2 tank.

Priming the coil – There are 4 holes around the outside of the coil, through which you can see the cotton inside. Drip some e-liquid in each hole and some on the mesh at the top, then repeat these actions. Once you have soaked enough liquid into the coil, just blow firmly from the top to remove any excess liquid (holding the coil with tissues is recommended!)

Once that is done, screw the coil into the base and then screw it back onto your e-liquid filled tank. Allow the coil to soak in the liquid for at least 20-30 minutes, to ensure it has been fully primed.

To get the most out of your coil, change it just before you go to bed and just leave it to soak overnight. Remember to fill up with fresh e-liquid and rinse out the tank when installing a new coil, as the previous coil may leave a residue in the liquid and could still taste burnt!

The internet suggests that the following coils are all compatible: Eleaf Ijust 2,Eleaf Ijust-S,Eleaf EC Coils,Eleaf ECL Coils,Aspire Triton,Aspire Triton 2,Aspire Atlantis,Eleaf Melo II,Eleaf Melo III